欢迎来到研茂智能装备(苏州)有限公司官网!

CN

1591596640179948.png   咨询热线:400-850-175

新闻banner
Location : Home >> News >> Industry information

Contact Us

Yanmao intelligent equipment (Suzhou) Co., Ltd

Contact person: Mr. Ren

Contact person: Mr. Liu

Tel: 400-850-1759

Tel: 400-850-1758

website: www.zbsmdj.cn

Address: Building 8, Taisheng Industrial Park, No. 11, Xingye South Road, high tech Zone, Taicang City, Jiangsu Province

How to avoid the safety accident when operating the sealing machine

2020-06-02 17:28:05

Although the sealing machine is a relatively small packaging equipment, but after all, it is a professional packaging machinery, in the use of a lot of safety precautions, to avoid the occurrence of safety accidents. Therefore, attention should be paid to the following aspects when operating the sealing machine:

Before using the sealing machine, the ground wire must be well connected. When working, hands or hard objects should not be put between the head and the back cover to avoid damage to the equipment or danger.

It is forbidden to touch the silicone rubber strip at the back cover with sharp objects to prevent the rubber strip from being scratched and thus affecting the sealing quality. Polytetrafluoroethylene cloth on the head and back cover should be replaced regularly to ensure the sealing quality of the packaging products, so as to reduce the damage rate.

After sealing, the finished bag should be carefully placed in a suitable place, and then moved after natural cooling for two or three seconds. Do not immediately squeeze or impact the bag to avoid leakage. Before working every day, wipe the moving friction surface on the head, remove the dirt on it, and add proper amount of lubricating oil. Pay attention that the pneumatic part does not need to be lubricated.

When the room temperature is below 10 ℃, it is not suitable for start-up work, so as to prevent cylinder damage and error action. In case of air leakage or failure, the cylinder shall be cleaned or replaced in time. If the machine is not started for a long time, it should be started up again one month after the first time. At this time, the starting pressure is 0.7MPa. After working for a period of time, the pressure is adjusted to 0.5, and the machine is shut down after 10 minutes.

Recently: